Chongqing gold mechnical and electrical equipment Co., Ltd
Chongqing gold mechnical and electrical equipment Co., Ltd
Add to Cart
ASTM E162 Test Analyzer Radiant Panel Flame Spread ASTM D3675 Laboratory Fire Testing
ASTM E162 Radiant Panel Flame Spread Tester Product Introduction:
The radiant panel flame propagation test system uses standardized thermal radiation sources (such as ASTM E162 and ISO 12136) to determine the ignition characteristics and flame propagation rate of building materials and composite materials under controlled thermal radiation conditions. The system provides compliance evidence for rail transportation (EN 45545), aerospace (FAR 25.853) and building fire protection (NFPA 286) by quantifying key parameters such as heat release rate (HRR), critical radiant flux (CRF) and flame spread index (FGI).
ASTM E162 Radiant Panel Flame Spread Tester Standards:
• ASTM E 162: Standard Test Method for Surface Flammability of Materials Using Radiant Heat Energy Source
• ASTM D 3675: Standard Test Method for Surface Flammability of Flexible Porous Materials Using Radiant Heat Energy Source
ASTM E162 Radiant Panel Flame Spread Tester Technical Specification:
| Model | GD-ASTM E162 |
| Console Size | 600(W)*750(D)*1600(H)mm |
| Size | 1,850(W)*700(D)*1,260(H)mm |
| Power | AC 220V, 50/60Hz, 15A |
| Weigh | 150kg |
ASTM E162 Radiant Panel Flame Spread Tester features:
• The frame structure is made of stainless steel; beautiful and corrosion-resistant;
• The filter is equipped with a fan to supply air to the reflector
• Equipped with a pilot, electronic ignition, and automatic flameout safety monitoring device
• Stainless steel sample holder, with observation points every 3 inches to observe the progress of the flame front
• Stainless steel sample holder and pilot burner device
• Air flow meter, gas control valve, control the gas mixture sent to the radiation plate
• Stainless steel exhaust pipe with removable parts for easy cleaning of thermocouples, the exhaust pipe is equipped with 8 thermocouples according to the standard
• The calibration burner has 1.8mm holes at 16 different angles and must be along the center line
• Equipped with insulated thermocouples to measure the temperature of the stack;
• DAQ system can realize automatic control and measurement
• Gas safety control and circuit cut-off device